Klimax DSM /0 (2011 Variant)

From LinnDocs
Revision as of 12:07, 9 March 2021 by Yoda (talk | contribs)
Jump to: navigation, search

<< Klimax DSM/2 (2016/2018 Variant) Klimax DSM/1 (2014 Variant) >>

KLIMAX DSM
(Original version)

KlimaDS 3Q 02 low res.jpg

Product info

  • Product Name: Klimax DSM (2011 Variant)
Other variants of this product can be found at Klimax DSM Variants
  • Date of Introduction: October 2011 - May 2014
Replaced by Klimax DSM/1
  • Type: Integrated digital music player and preamplifier



Hardware Upgrades
HDMI 2.0 Upgrade

Note: It should be noted that information may at times be out of date and should not be used as a current list of what upgrades are available.

Support

Linn Support Site

Latest software

Latest software releases

Details of latest Product release software

Manuals

Quickstart Guide

Controlling the product User Guide

Product setup:Manage Systems user manual

Space Optimisation (Advanced)

Safety Information

Warranty Terms and Conditions

Third Party Software Copyright

HDMI Setup

HDMI Setup

DSM Audio Latencies Explained

Network Setup

Back Panel Connections

Image:Klimax_DSM_rear.jpg


  1. MAINS INPUT - To connect to the mains electricity supply.
  2. FALLBACK - To put the device into Fallback mode (used when reprogramming)
  3. TOSLINK IN- To connect sources with Toslink (optical) digital outputs.
  4. ETHERNET - To connect to a network (100Base-T)
  5. SPDIF IN - To connect sources with Spdif digital outputs.
  6. BALANCED IN RIGHT, LEFT - To connect sources with balanced (XLR) outputs.1 2
  7. BALANCED OUT RIGHT, LEFT - To connect to a preamplifier (or power amplifier when internal volume control is enabled) with balanced (XLR) analogue inputs.2
  8. UNBALANCED OUT RIGHT, LEFT - To connect to a preamplifier (or power amplifier when internal volume control is enabled) with unbalanced (RCA) analogue inputs.
  9. EARTH GROUND - For connecting the unit to an earthing terminal if no mains earth is available or for joining the earths of other products in the system to improve perfromance in areas of poor/noisy electrical earth conditions.
  10. HDMI IN 1, 2, 3 - To connect sources with HDMI outputs.
  11. HDMI OUT - To connect to a display device with HDMI inputs.


1 XLR to RCA adaptors are supplied for connecting sources with unbalanced outputs.
2 Set to DELAY mode > DIRECT to pass through an Analogue volume control to the Analogue out.

Front Panel

Image:Klimax_DSM_front.jpg


  1. DISPLAY
  2. ON / OFF SWITCH


Installation

Please read the following carefully before installing the unit in your system – your unit may need to be reconfigured by your Linn retailer.


FAQ's

Check:


For further assistance, try our customer support pages