Difference between revisions of "Sekrit DSM"

From LinnDocs
Jump to: navigation, search
(Created page with 'right|350px == '''Product info''' == * ''Product Name:'' Sekrit DSM * ''Date of Introduction:'' December 2012 * ''Type:'' Integrated digital music play…')
 
(Product info)
Line 10: Line 10:
 
* ''Features''  
 
* ''Features''  
 
** [http://docs.linn.co.uk/wiki/index.php/Why_Linn_DS_is_the_best_way_to_play_CDs DS Design]
 
** [http://docs.linn.co.uk/wiki/index.php/Why_Linn_DS_is_the_best_way_to_play_CDs DS Design]
** ** [http://docs.linn.co.uk/wiki/index.php/Unity_Gain Source Unity Gain option]
+
** [http://docs.linn.co.uk/wiki/index.php/Unity_Gain Source Unity Gain option]
  
 
== '''Support''' ==
 
== '''Support''' ==

Revision as of 13:22, 4 December 2012

Product info

  • Product Name: Sekrit DSM
  • Date of Introduction: December 2012
  • Type: Integrated digital music player, pre-amplifier, and power amplifier

Support

Linn Support Site

Latest software

Latest software releases

Open source software

Manuals

Konfig manual

Kinsky Desktop manual

DSM Remote control manual

Safety Information

Warranty Terms and Conditions

HDMI Setup

HDMI Setup

Network Setup

DS Budget System Setup

DS Entry Level System Setup

DS High End System Setup


Back Panel Connections

61613Rear1.jpg
  1. POWER SWITCH- Switches the power on/off
  2. MAINS INPUT - To connect to the mains electricity supply.
  3. FALLBACK- To put the device into Fallback mode (used when reprogramming).
  4. ETHERNET - To connect to a network.
  5. HDMI OUTPUT - To connect to a display device with HDMI inputs.
  6. HDMI INPUTS - To connect sources with HDMI outputs.
  7. DIGITAL INPUT (Toslink) - To connect sources with Toslink (optical) digital outputs.
  8. DIGITAL INPUT (Spdif) - To connect sources with Spdif (RCA) digital outputs.
  9. ANALOGUE INPUT (line level) - To connect a turntable or line level source with unbalanced (RCA) outputs.
  10. SPEAKER OUTPUTS - To connect to loudspeakers


Front Panel Connections

61613Front.jpg
  1. IR SENSOR - Recieves IR commands
  2. DIAGNOSTIC LEDS - See table below for functionality
  3. FALLBACK (F-BACK) - To put the device into Fallback mode (used when reprogramming).


DIAGNOSTIC LED FUNCTIONS

Text

ON

indicates

OFF

indicates

Slow Flash / Blink

Fast Flash

IR Pulse on IR command received Reserved for future use Reserved for future use n/a
P-AMP Internal amplifier enabled Internal amplifier disabled Internal amplifier fault n/a
AUDIO Valid audio (digital inputs only) n/a Invalid audio (digital inputs only) n/a
DHCP DHCP IP address obtained Default IP address obtained n/a n/a
LINK Ethernet link established no link established n/a n/a
STBY Device in standby Device active Searching for IP address (boot) Fallback (reprogramme)

*NOTE: All LED's will flash if 'Locate Device' request is invoked from Konfig


Installation

Please read the following carefully before installing the unit in your system – your unit may need to be reconfigured by your Linn retailer.

For further assistance, try our customer support pages or the Linn Forum.