Difference between revisions of "Sekrit DS-I"

From LinnDocs
Jump to: navigation, search
(Manuals)
m (Product info)
Line 7: Line 7:
 
* ''Date of Introduction:'' October 2009
 
* ''Date of Introduction:'' October 2009
  
* ''Type:'' Digital Stream Player.
+
* ''Type:'' Digital music player
  
 
* ''Features''  
 
* ''Features''  

Revision as of 15:45, 7 November 2011

Sekrit DS-I front rightl RGB 72DPI.jpg

Product info

  • Product Name: Sekrit DS-I
  • Date of Introduction: October 2009
  • Type: Digital music player

Latest software

Latest software releases

Open source software

Manuals

Product Information

Konfig manual

Kinsky Desktop manual

Remote Control manual

Kinsky Jukebox manual

Safety Information

On-line warranty registration

Network Setup

Back Panel Connections

Image:Sekrit_DSI_rear.jpg


  1. MAINS INPUT - To connect to the mains electricity supply.
  2. EARTH GROUND - To connect to an earthing terminal if no mains earth is available or to join to the earths of other products in the system to improve performance in areas of poor/noisy electrical earth conditions.
  3. SPEAKER OUTPUTS - To connect to loudspeakers.
  4. ANALOGUE OUTPUTS (RCA, variable/fixed level) - To connect to a preamplifier (or power amplifier when internal volume control is enabled) with unbalanced (RCA) analogue inputs.
  5. ANALOGUE INPUTS (RCA, line level) - To connect sources with unbalanced (RCA) analogue outputs.
  6. RC5 ACCESSORY - To coonect BASIK-3 & BASIK-3IR Room Control units
  7. IR OUTPUTS - To connect to infrared flasher devices allowing control of other products that accept infra-red signals.
  8. RS232 PORTS - To connect to other Linn devices that don't have ethernet.
  9. ETHERNET - To connect to a network.
  10. DIGITAL INPUT (Spdif) - To connect sources with Spdif (RCA) digital outputs.
  11. DIGITAL INPUT (Toslink) - To connect sources with Toslink (optical) digital outputs.


Front Panel Connections

Image:Sekrit_DSI_front.jpg


  1. POWER SWITCH - Switches the power on/off
  2. FALLBACK BUTTON - To put the device into Fallback mode (used when reprogramming)


LED FUNCTIONS

Text

ON

indicates

OFF

indicates

Slow Flash / Blink

Fast Flash

STANDBY Device in standby Device active Searching for IP address (boot) Fallback (reprogramme)
LINK Ethernet link established no link established n/a n/a
DHCP DHCP IP address obtained Default IP address obtained n/a n/a
AUDIO Valid audio (digital inputs only) n/a Invalid audio (digital inputs only) n/a
POWER AMP Internal amplifier enabled Internal amplifier disabled Internal amplifier fault n/a
RCU Reserved for future use Reserved for future use Reserved for future use n/a
SEARCH n/a n/a Find me n/a
TRANSMIT Reserved for future use n/a n/a n/a


Installation

Please read the following carefully before installing the unit in your system – your unit may need to be reconfigured by your Linn retailer.

  • Unpacking - Please read the information on unpacking your Sekrit DS-I.
  • Positioning - Please read the information on positioning your Sekrit DS-I.
  • Important Information:Protection - The Sekrit DS-I features over-current and over-temperature protection

For further assistance, try our customer support pages or the Linn Forum.