Akurate Kontrol (Ethernet)

From LinnDocs
Revision as of 13:25, 19 April 2013 by Eamonnb (talk | contribs) (Back Panel Connections)
Jump to: navigation, search
AkurateKontrolFrontTop.jpg

Product info

  • Product Name: Akurate Kontrol
  • Date of Introduction: November 2010
  • Type: Analogue Preamplifier

Support

Linn Support Site

Latest software

Latest software releases

Open source software

Manuals

Quickstart Guide

Product Infomation Sheet

Konfig manual

Kinsky Desktop manual

Remote Control manual

Safety Information

Warranty Terms and Conditions

Network Setup

DS Budget System Setup

DS Entry Level System Setup

DS High End System Setup

Back Panel Connections

AkurateKontrolBack.png


  1. MAINS INPUT - To connect to the mains electricity supply.
  2. EARTH GROUND - To connect to an earthing terminal if no mains earth is available or to join to the earths of other products in the system to improve performance in areas of poor/noisy electrical earth conditions.
  3. FALLBACK - To put the device into Fallback mode (used when reprogramming).
  4. ETHERNET - To connect to a network.
  5. ANALOGUE INPUTS (XLR, line level) - To connect sources with balanced (XLR) outputs.
  6. ANALOGUE INPUTS (RCA, line level) - To connect sources with unbalanced (RCA) outputs.
  7. ANALOGUE INPUTS (RCA, phono/line level) - To connect a turntable or line level source with unbalanced (RCA) outputs.
  8. PHONO GROUND - To connect to a turntable grounding terminal.
  9. ANALOGUE OUTPUTS (XLR,variable level) - To connect to a power amplifier with balanced (XLR) analogue inputs.
  10. ANALOGUE OUTPUTS (RCA, variable level) - To connect to a power amplifier with unbalanced (RCA) analogue inputs.
  11. ANALOGUE OUTPUTS (RCA, fixed level) - To connect to an analogue recording device with unbalanced (RCA) inputs.

Front Panel Connections

AkurateKontrolFront.png
  1. MUTE BUTTON - Mutes/unmutes the audio
  2. VOLUME ADJUST BUTTONS - Changes the volume up/down
  3. HEADPHONE OUTPUT - To connect to stereo headphones with a 3.5mm input
  4. AUX SOURCE INPUT - To connect to a stereo audio source with a 3.5mm output
  5. SOURCE SELECT BUTTONS - Changes to the previous/next source
  6. STANDBY BUTTON - Brings the unit in/out of standby
  7. POWER SWITCH- Switches the power on/off
  8. FRONT PANEL DISPLAY

Installation

Please read the following carefully before installing the unit in your system – your unit may need to be reconfigured by your Linn retailer.


For further assistance, try our customer support pages or the Linn Forum.