|
|
Line 10: |
Line 10: |
| | | |
| | | |
− | [[Image:AkubarikE_ON.jpg|right|200x110px|Image:AkubarikE_ON.jpg]]
| |
− | When the Exakt DSM is brought out of Standby it will send trigger voltage and wake the speaker up. The LED's beside the Mains socket/Exakt link sockets will tell you the status.
| |
− | After approx 6seconds the Blue LED on the top of the speaker will illuminate stating "its ready to party!"
| |
| | | |
| | | |
− | '''Signal sensing'''
| |
| | | |
− | [[Image:Akubarik_blue_leds.jpg|right|200x110px|Image:Akubarik_blue_leds.jpg]]
| |
| | | |
− | When an input signal is detected, the Chakra amplifier is enabled and the blue LED
| + | [[Image:AkubarikE_ON.jpg|right|200x110px|Image:AkubarikE_ON.jpg]] |
− | lights (red LED goes off).
| + | When the Exakt DSM is brought out of Standby it will send trigger voltage and wake the speaker up. The LED's beside the Mains socket/Exakt link sockets will tell you the status. |
− | In the absence of an audio signal, the amplifier reverts to a sleep mode after approximately 20 minutes.
| + | After approx 6seconds the Blue LED on the top of the speaker will illuminate stating "its ready to party!" |
− | | |
− | | |
− | | |
− | ==='''Protection'''===
| |
− | | |
− | | |
− | '''Operation'''
| |
− | | |
− | If an amplifier channel overheats or detects an overload condition, the power supply for
| |
− | that channel will shut down in order to protect the amplifier and the loudspeaker drive
| |
− | unit(s) to which it is connected.
| |
− | | |
− | [[Image:Akubarik_blue_and_red_leds.jpg|right|200x110px|Image:Akubarik_blue_and_red_leds.jpg]] | |
− | | |
− | '''Duration'''
| |
− | | |
− | Once the condition that caused the amplifier to activate its protection has passed, the
| |
− | amplifier will automatically resume normal operation. How long the channels remain in
| |
− | protection will depend on the cause. If the protection operates for more than a few
| |
− | seconds, it could indicate overheating which may take some minutes of cooling to
| |
− | rectify.
| |
Revision as of 15:12, 10 June 2014
Operation
General
If the Exakt DSM is in Standby, the Akubarik speaker is totally shutdown.
No LED's or indicators are shown
When the Exakt DSM is brought out of Standby it will send trigger voltage and wake the speaker up. The LED's beside the Mains socket/Exakt link sockets will tell you the status.
After approx 6seconds the Blue LED on the top of the speaker will illuminate stating "its ready to party!"