Template:General:Series3-301 TI Indicators

10. Volume indicator

Click for more....

. Primarily the outer ring is the volume level indicator.

This also has other indications:

⊕ Initial startup/power on, the full volume ring will pulse slowly. This indicates that the Series3 is either

⁃ Starting up, this typically takes 20-40seconds, or

⁃ Doing a software update. This should take less than 10minutes (If this takes longer then double check that you have Ethernet cable plugged into the LAN socket and NOT the Exakt socket)

⊕ Press any of the Favourite/PIN buttons, the volume indicator will illuminate beside this button to show that it has been selected

⊕ lights scanning from from top to bottom, bottom to top indicate with in Bluetooth scan or Wifi Scan

11. Linn icon

Click for more....

If you do not have a live Wifi/network/LAN connection on the Series-3 then the Linn symbol on the dial will go red.
If you are select the HDMI-ARC input or Bluetooth to the Series3 speaker this red light will go out

If your network cable is plugged in and your network/LAN is alive then check that you have the network/LAN cable plugged into the LAN socket and NOT the Exakt socket.

This means that the Selekt DSM is in FALLBACK mode.

Fallback is a state that means that the product is waiting for a software update. To stop this flashing either:

• Power cycle (Switch Mains Off for 10seconds and then switch mains On) and leave the Selekt DSM to startup for approximately 1min.

or

• Use the Konfig software to upload software in to the Linn Selekt DSM