Difference between revisions of "Sneaky Music DS"

From LinnDocs
Jump to: navigation, search
(System Setup)
(Back Panel Connections)
Line 39: Line 39:
== '''Back Panel Connections''' ==
== '''Back Panel Connections''' ==
[[Image:Sneaky DS rear.jpg|center|720x230px|Image:Sneaky_DS_rear.jpg]]
[[Image:Sneaky DS rear.jpg|center|720px]]
# '''MAINS INPUT''' - For connection to the mains supply.
# '''MAINS INPUT''' - For connection to the mains supply.

Revision as of 17:20, 14 December 2010

SneakyMusicDS Silv 3QRight RGB 72DPI.jpg

Product info

  • Product Name: Sneaky Music DS
  • Date of Introduction: March 2008
  • Type: Network Music Player.

Latest software

Latest software releases

Open source software


Linn Konfig manual

Kinsky Desktop manual

Kinsky Jukebox manual

Production Information Sheet, including Product Specifications

Generic Safety Information

On-line warranty registration

System Setup

Network setup guide.

Back Panel Connections

Sneaky DS rear.jpg
  1. MAINS INPUT - For connection to the mains supply.
  2. EARTH GROUND - For connecting the unit to an earthing terminal if no mains earth is available or for joining the earths of other products in the system to improve perfromance in areas of poor/noisy electrical earth conditions.
  3. SPEAKER OUTPUTS RIGHT, LEFT - Amplified output for connection to loudspeakers
  4. ANALOGUE AUDIO OUTPUTS RIGHT, LEFT - Analogue outputs for connection to a pre-amplifier or directly to a power amplifier if the internal volume control is enabled.
  5. TOSLINK OUT - For connecting to a device with a digital optical input.
  6. SPDIF OUT - For connecting to a device with a digital electrical (coaxial) input.
  7. RCU ACCESSORY - For connecting to Linn BASIK3 or BASIK3-IR.
  8. RS232 PORTS - For connection to Linn source products without ethernet ports.
  9. FALLBACK - Used when reprogramming the unit.
  10. ETHERNET - For connecting the unit to the network.

Front Panel Connections

SneakyMusicDS Silv Front RGB 72DPI.jpg

Product status is indicated by the LED behind the Linn badge, default settings are shown below.

LED OFF - no power
LED ON DIM - product in standby
LED ON BRIGHT - product is active
LED SLOW FLASH - searching for IP address (boot)
LED FAST FLASH - fallback (re-programme)

Note: LED may be turned off using Linn Konfig.


Please read the following carefully before installing the unit in your system – your unit may need to be reconfigured by your Linn retailer.

  • Unpacking - Please read the information on unpacking your Sneaky Music DS.
  • Positioning - Please read the information on positioning your Sneaky Music DS.
  • Important Information:Protection - The Sneaky Music DS features over-current and over-temperature protection

For further assistance, try our customer support pages or the Linn Forum.