Difference between revisions of "Sekrit DSM"

POWER SWITCH- Switches the power on/off
MAINS INPUT - To connect to the mains electricity supply.
FALLBACK- To put the device into Fallback mode (used when reprogramming).
ETHERNET - To connect to a network.
HDMI OUTPUT - To connect to a display device with HDMI inputs.
HDMI INPUTS - To connect sources with HDMI outputs.
DIGITAL INPUT (Toslink) - To connect sources with Toslink (optical) digital outputs.
DIGITAL INPUT (Spdif) - To connect sources with Spdif (RCA) digital outputs.
ANALOGUE INPUT (line level) - To connect a turntable or line level source with unbalanced (RCA) outputs.
SPEAKER OUTPUTS - To connect to loudspeakers
ANALOGUE OUTPUT (RCA, variable/fixed level) - To connect to a preamplifier (or power amplifier when internal volume control is enabled) with unbalanced (RCA) analogue inputs.
RC5 ACCESSORY - To connect BASIK-3 & BASIK-3IR Room Control units.
IR OUTPUTS - To connect to infrared flasher devices allowing control of other products that accept infra-red signals.

Front Panel Connections

IR SENSOR - Recieves IR commands
DIAGNOSTIC LEDS - See table below for functionality
FALLBACK (F-BACK) - To put the device into Fallback mode (used when reprogramming).

DIAGNOSTIC LED FUNCTIONS

Text	ON indicates	OFF indicates	Slow Flash / Blink	Fast Flash
IR	Pulse on IR command received	Reserved for future use	Reserved for future use	n/a
P-AMP	Internal amplifier enabled	Internal amplifier disabled	Internal amplifier fault	n/a
AUDIO	Valid audio (digital inputs only)	n/a	Invalid audio (digital inputs only)	n/a
DHCP	DHCP IP address obtained	Default IP address obtained	n/a	n/a
LINK	Ethernet link established	no link established	n/a	n/a
STBY	Device in standby	Device active	Searching for IP address (boot)	Fallback (reprogramme)

*NOTE: All LED's will flash if 'Locate Device' request is invoked from Konfig

Please read the following carefully before installing the unit in your system – your unit may need to be reconfigured by your Linn retailer.

For further assistance, try our customer support pages or the Linn Forum.

Revision as of 13:27, 4 December 2012 (view source) Hahnj21 (talk \| contribs) (→‎Installation) ← Older edit		Revision as of 13:27, 4 December 2012 (view source) Hahnj21 (talk \| contribs) (→‎Installation) Newer edit →
Line 149:		Line 149:

	* [http://docs.linn.co.uk/wiki/index.php/amplifier_protection Amplifier Protection]		* [http://docs.linn.co.uk/wiki/index.php/amplifier_protection Amplifier Protection]
		+

	For further assistance, try our [http://www.linn.co.uk/linn_customer_support customer support] pages or the [http://Forums.linn.co.uk Linn Forum.]		For further assistance, try our [http://www.linn.co.uk/linn_customer_support customer support] pages or the [http://Forums.linn.co.uk Linn Forum.]