Difference between revisions of "DS Entry Level System"

From LinnDocs
Jump to: navigation, search
(Step 2: Connect NAS to router)
(Step 3: Connect DS to router)
Line 43: Line 43:
 
[[image:Entry2.png|centre]]
 
[[image:Entry2.png|centre]]
  
==Step 3: Connect DS to router==
+
==Step 3: Connect DS To Router==
  
Connect the DS player to the router then power it on. The DS should automatically obtain its reserved IP address from the router.
+
Connect the Linn DS player to the router then power it on. The Linn DS should automatically obtain its reserved IP address from the router.
  
  
 
[[Image:Entry3.png|center]]
 
[[Image:Entry3.png|center]]
 
  
 
==Step 4: Install DS control software on computer==
 
==Step 4: Install DS control software on computer==

Revision as of 13:41, 2 November 2010

Introduction

This is a recommended guide to setting up an entry level DS system, requiring you to purchase some network components in order to build the recommended system.


DIAGRAM (FULL SYSTEM)


It is advisable to follow the instructions step by step to ensure that each part of the system is working before moving on to the next. By doing this, it simplifies the setup process and allows for any problems encountered to be more easily identified and resolved.

Required Components

The following components are required for the system detailed in this page:

  • Router
  • Home coputer
  • Linn DS
  • NAS


Notes:

  1. Ethernet cables are required to connect devices
  2. Router is required to have built in switch and feature address reservation
  3. NAS is required to have media server software (Twonky or Asset UPnP) and backup support
  4. If a wireless router is being used, n band WAP support is recommended

Step 1: Connect Computer To Router

  1. Connect the computer to the router.
  2. Configure the router to the recommended settings.


Entry1.png

The computer’s network adapter should already be configured to ‘Obtain an IP address automatically’.

Step 2: Connect NAS To Router

  1. Connect the NAS to the router.
  2. Ensure the DHCP server is disabled on the NAS and configure the NAS to ‘Obtain an IP address automatically’.
Entry2.png

Step 3: Connect DS To Router

Connect the Linn DS player to the router then power it on. The Linn DS should automatically obtain its reserved IP address from the router.


Entry3.png

Step 4: Install DS control software on computer

DS control software (e.g. Kinsky Desktop) must now be installed on the computer. The latest Linn DS software downloads and manuals can be found here. It should now be possible to play music throught the DS.

Step 5: Adding wireless control

If desired, a wireless access point (WAP) can be added to the network to allow wireless control of the DS through a portable, wireless enabled control point (such as a laptop, mobile phone, etc.).


Entry4.png