DS Entry Level System

Introduction

This is a recommended guide to setting up an entry level DS system, requiring the customer to purchase some network components in order to build the recommended system.

It is advisable to follow the instructions step by step to ensure that each part of the system is working before moving on to the next. By doing this, it simplifies the setup process and allows for any problems encountered to be more easily identified and resolved.

The following components are required for the system detailed in this page:

• Router with built in switch and DHCP server; it should also feature address reservation.
  • If a wireless router is being used, n band WAP support is recommended
• NAS with media server software (Twonky or Asset UPnP) and RAID or backup support
• Home computer (control point)
• DS Player
• Network cables

Step 1: Connect computer to router

Connect the home computer to the router using a standard ethernet cable. The computer’s network adapter should be configured to ‘obtain an IP address automatically’. Configure the router to have an IP address of 192.168.72.1, and enable its DHCP server to issue IP addresses in the range 192.168.72.100...200.

Step 2: Connect NAS to router

Connect the NAS to the router using a standard ethernet cable. Ensure the DHCP server is disabled on the NAS and configure the NAS to 'obtain an IP address automatically'.

Step 3: Connect DS to router

Connect the DS player to the router. The DS should automatically obtain its reserved IP address from the router. The system should now be connected as shown below.

==Step 4: Install DS control software on computer

The latest release of Konfig and Kinsky Desktop should be installed on the computer