Template:Build Series 3 Stand

Fitting the Stand

This is an accessory to Series3 that allows the loudspeaker to bolt on stand.

The cables can be hidden through the centre of the stand. Rubber feet, supplied, can be fitted at the bottom of the stand for added cable clearance..

Install instuctions:

1. Have all parts ready to assemble, and a clean, soft surface to work on.

2. Turn the stand upside-down and feed the cables you require through the stand. Pull the cables out through the hole provided at the rear of the stand.

3. Gently and carefully place the Series 3 speaker on its head. Line up the hole in the top of the stand with the insert in the cabinet.

     a) Take the bolt and washer and start fitting the bolt by hand to ensure you are not cross threading.
     b) Tighten the bolt to secure, but take care not to overtighten it, as this could crack the speaker cabinet.

4. Turn the stand the right way up and plug the cables into the connectors. The product is now ready to connect and install

5. Optional rubber bump on feet can be fitted to the base if the stand is going to be used on a wooden floor, to avoid scratching. Arrange the feet equally spaced around the perimeter.