REM 020

Operation with Linn DSM

The following functionality is available on Linn DSM devices with Infra-Red (IR) control. If IR is not currently enabled on the Linn DSM then this can be done via Linn Konfig.

To Enable IR

• Open Konfig
• Select the Linn DSM
• Select the Configuration tab
• Set Handset Commands Accepted to All or CD depending on user requirement

Basic Functions

1. SLEEP - Will put the unit into / out of Sleep mode.
2. NUMERICAL KEYS - Numerical input.
3. # - Press and hold for 2 seconds for HELP information

   e.g. IP address, MAC etc.

4. * - No function.
5. NAVIGATION / SELECT - Up / down / left /right

   / enter keys for playlist navigation.

6. DS SOURCE SELECTION - For switching between "Songcast",

   "Playlist" and "Radio" sources on your DSM.

7. INPUT SOURCE SELECTION - Direct source selection buttons,

   see below for default settings and how to change them.

8. TRANSPORT CONTROLS - Play, pause, skip forward, skip back.
9. MUTE - To mute / unmute volume.
10. VOLUME + , - - Volume + , -.
11. SOURCE + , - - Source + , -.
12. INFORMATION - changes information displayed on the DSM

    front panel

• Press and release - toggles different display modes e.g. track

number, bit rate etc

• Press and hold scrolls title / artist / album information

Direct Source Selection

The default settings for the direct source selection buttons is shown below.

Product	Source 1	Source 2	Source 3
Klimax DSM	hdmi 1	hdmi 2	hdmi 3
Akurate DSM	hdmi 1	hdmi 2	hdmi 3

These settings can be changed either with the handset or using Linn Konfig.

Using the handset

• On the DSM, go to the source that you want the remote button to select.
• Press and hold the chosen source button on the handset e.g.

until the DSM displays SET.

Using Konfig

• Open Konfig and select the unit you want to update
• Open the Configuration tab
• Scroll down to the section Slimline Handset
• Highlight the Input button you wish to change and then select the source from the drop down list.