Template:Setup:Majik Sub

This will ONLY work in Power Out or Line Output configurations. This cannot be used in Exakt-linked loudspeakers.

These outputs are to give Stereo music enhancement on the Linn DSM using the Speaker Outputs for L+R feed and using generic filters for the Sub Output. (Due to timing issues, it does NOT work properly with Exakt connected speakers. You will need to use the Exaktbox-Sub for this operation.)

In Manage Systems - Output options

Subwoofer

Options:

* ENABLED to enable these back panel outputs.

* DISABLED to disable these back panel outputs.

Subwoofer Filter

• Enabled SUBOUT L+R set by crossover frequency 60Hz, 80Hz, 120Hz .
• Disabled SUBOUT L+R crossover frequency 1kHz, the LHC/RHC audio is flat.

Subwoofer Crossover Frequency

If Subwoofer filter is enabled:

• 60 Crossover frequency 60Hz
• 80 Crossover frequency 80Hz
• 120 Crossover frequency 120Hz

Subwoofer Crossover Type

• Bass redirect Audio above the Subwoofer Crossover Frequency frequency is sent to the F+R channels. (Audio below this frequency is redirected to the SUBOUT outputs.)
• Bass Reinforcement Audio to the F+R channels is as a flat response.

Subwoofer Channels

• Mono L+R subwoofer combined into one output.
• Stereo separate LHC and RHC subwoofer outputs

Notes

• Does NOT work with DSD playback
• The output level is solely controlled by the Linn DSM volume control. Any Sub trim should be performed at the subwoofer.