DS High End System

Introduction

This is a recommended guide to setting up a high end Linn DS system, requiring all of the specified network components to be purchased, ensuring that they meet the stated specifications.

DIAGRAM (FULL SYSTEM)

It is advisable to follow the instructions step by step to ensure that each part of the system is working before moving on to the next. By doing this, it simplifies the setup process and allows for any problems encountered to be more easily identified and resolved.

Required Components

The following components are required for the system detailed in this page:

• Router
• Home coputer
• Linn DS
• NAS

Notes:

1. Ethernet cables are required to connect devices
2. Router is required to have built in switch and feature address reservation
3. NAS is required to have media server software (Twonky or Asset UPnP) and backup support
4. If a wireless router is being used, n band WAP support is recommended

The following components are required for the system detailed in this page:

• Router with built in DHCP server; it should also feature address reservation.
• Network switch
• Wireless access point
• NAS with media server software (Twonky or Asset UPnP) and backup support
• Home computer (control point)
• Wireless control device
• DS Players
• Network cables

Step 1: Connect router to switch

Connect the router to the switch using a standard ethernet cable.

Step 2: Connect computer to switch

Connect the home computer to the switch using a standard ethernet cable. The computer’s network adapter should be configured to ‘obtain an IP address automatically’. Configure the router to the recommended settings.

Step 3: Connect NAS to switch

Connect the NAS to the switch using a standard ethernet cable. Ensure the DHCP server is disabled on the NAS and configure the NAS to 'obtain an IP address automatically'.

Step 4: Connect DS to switch

Connect the DS player to the switch then switch it on. The DS should automatically obtain its reserved IP address from the router.

Step 5: Install DS control software on computer

Once the system has been set up as shown above, the DS control software (e.g. Kinsky Desktop) must be installed on the computer. The latest Linn DS software downloads can be found here. It should now be possible to play music throught the DS.

Step 6: Add wireless access point

A wireless access point (WAP) can now be added in to the system. A wireless control device (such as a PDA, iPhone, etc.) can be used to verify that this is working.