Difference between revisions of "KlimaxSolo:Auto-Standby"
(Created page with ":This allows more settings in the Auto-Standby function and overall power used. ::<big><b>3</b></big>: <b><i>No</i></b> auto-standby. (Never enters Low-Power mode) ::<big><b>2...") |
(No difference)
|
Revision as of 14:34, 22 May 2025
- This allows more settings in the Auto-Standby function and overall power used.
- 3: No auto-standby. (Never enters Low-Power mode)
- 2: "Shallow" auto-standby after 20 minutes without a signal. Almost immediate audio upon waking up.
- 1: "Deep" auto-standby after 20 minutes without a signal. Audio will take a few seconds before waking up.
- Note:
- 12V Trigger and Auto-Standby behaviour
- with 12V trigger plugged in and not enabled, Solo 500 will be in "Deep" standby.
- with 12V trigger enabled, amp will go into running state but will go into deep or shallow after 20 minutes without signal if switch position 1 or 2.
- with switcn in position 3, amp standby will be fully controlled by 12V trigger in.
- 12V Trigger and Auto-Standby behaviour
