Wiring and configuration of Linn DS with Surround Processor

From LinnDocs
Revision as of 14:27, 29 January 2015 by Yoda (talk | contribs) (Linn DSM with analogue video surround processors (e.g. AV5103/Kisto/Kinos))
Jump to: navigation, search

Connection diagram

Image:DSM_Vs_unity_5ch.jpg

LINN DS with Linn pre-amplifier and any surround processor

The Linn DS/DSM products do not have surround sound software to decode and playback surround sound streams such as Dolby Digital, DTS etc.

The Linn DS products you can setup an input on the some Linn Preamplifers, (such as the Klimax Kontrol/new Akurate Kontrol) to be unity gain. This wil allow you to select the surround processor in Kinsky/KazooUI and control the volume etc direclty on the Surround processor

Konfig Source setup - click to enlarge

The solution is to set the Linn DSM to have a unity gain input or if you are using a linn DS products you can setup an input on the some Linn Preamplifers, (such as the Klimax Kontrol/new Akurate Kontrol) to be unity gain.






Linn DSM and analogue surround processors

e.g AV5103/Kisto/Kinos/Akurate Kontrol) and/or with Exakt speakers

The Linn DSM can only process multi-channel PCM surround audio via the HDMI connections.

If you are using analogue video (SCART/Composite/RGB etc) surround processors, the surround audio is only available via SPDIF/TOSLINK. This type of connection do not support Multi-channel PCM audio, (this is the only surround format that the Linn DSM products can process).

Source settings - click to enlarge


The solution for the Linn DSM is to use an analogue input of the Linn DSM as the left/right aulio pass-thru: (diagram on top of this page)

  1. Setup an analogue input on the DSM for Unity Gain
  2. Setup the Delay mode for Direct
  3. If you are using the Exakt outputs on the Linn DSM you will need to compensate for the Exakt delay by changeing the speaker distances:
  • Front left/Right (Exakt speakers) to the furthest distance possible (28ft/8.5M on the Kinos/Kisto)
  • all other speaker distances, (including centre) to 0ft/0M


Startup-Mode.jpg

The Linn DSM will have no control over the Kisto/Kinos so we advise that

  • the startup source Enabled on Linn DSM is enabled and
  • set Startup source to the analogue input to which the Kisto/Kinos audio outputs are connected into.

The customer will have to bring the Linn DSM out sleep mode, this will then automatically select the analogue input.
NOTE: the IR commands for the Kisto/Kinos may also change the inputs on the Linn DSM, so advise that the IR is disabled on the Linn DSM and only controlled by the Kinsky/Kazoo UI.




The alternative is using Linn DSM products with HDMI connections