Sneaky Music DS

From LinnDocs
Revision as of 07:43, 5 June 2017 by Yoda (talk | contribs) (Product info)
Jump to: navigation, search
SneakyMusicDS Silv 3QRight RGB 72DPI.jpg

Product info

  • Product Name: Sneaky Music DS
  • Date of Introduction: March 2008 - June 2017 (Replaced by Sekrit DS)
  • Type: Digital music player

Support

Linn Support Site

Latest software

Latest software releases

Open source software

Manuals

Product Information Sheet

Owners Manual

Setup Manual

Konfig manual

Kinsky Desktop manual

Remote Control manual

Kinsky Jukebox manual

Space Optimisation+

Space Optimisation (Advanced)

Safety Information

Warranty Terms and Conditions

Third Party Software Copyright

Network Setup

DS Budget System Setup

DS Entry Level System Setup

DS High End System Setup

Back Panel Connections

Sneaky DS rear.jpg
  1. MAINS INPUT - To connect to the mains electricity supply.
  2. EARTH GROUND - To connect to an earthing terminal if no mains earth is available or to join to the earths of other products in the system to improve performance in areas of poor/noisy electrical earth conditions.
  3. SPEAKER OUTPUTS - To connect to loudspeakers
  4. ANALOGUE OUTPUTS (RCA, variable/fixed level) - To connect to a preamplifier (or power amplifier when internal volume control is enabled) with unbalanced (RCA) analogue inputs.
  5. DIGITAL OUT (TOSLINK) - To connect to an external DAC or computer that has a Toslink (optical) digital input.
  6. DIGITAL OUT (SPDIF) - To connect to an external DAC or computer that has an Spdif digital input.
  7. RCU ACCESSORY - To connect to a Linn BASIK3 or BASIK3-IR Knekt control device, (setup for RoomAmp2 connection (jumper link removed)). This requires a Knekt-CAT-5 cable to connect to the Linn DS
  8. RS232 PORTS - To connect to other Linn devices that don't have ethernet.
  9. FALLBACK - To put the device into Fallback mode (used when reprogramming)
  10. ETHERNET - To connect to a network.


Front Panel Connections

SneakyMusicDS Silv Front RGB 72DPI.jpg

Product status is indicated by the LED behind the Linn badge, default settings are shown below.

LED OFF - no power
LED ON DIM - product in standby
LED ON BRIGHT - product is active
LED SLOW FLASH - searching for IP address (boot)
LED FAST FLASH - fallback (re-programme)

Note: LED may be turned off using Linn Konfig.

Installation

Please read the following carefully before installing the unit in your system – your unit may need to be reconfigured by your Linn retailer.

For further assistance, try our customer support pages or the Linn Forum.