Sekrit DS-I

From LinnDocs
Revision as of 15:25, 11 December 2009 by IanW (talk | contribs)
Jump to: navigation, search
Sekrit DS-I front rightl RGB 72DPI.jpg

Product info

  • Product Name: Sekrit DS-I
  • Date of Introduction: October 2009
  • Type: Digital Stream Player.

Latest software

Latest software releases

Open source software

Manuals

Kinsky Desktop manual

Linn Konfig manual

Production Information Sheet, including Product Specifications

Generic Safety Information

On-line warranty registration

System Setup

Recommended DS Network setup guide


Back Panel Connections

Image:Sekrit_DSI_rear.jpg


  1. MAINS INPUT - For connection to the mains supply.
  2. EARTH GROUND - For connecting the unit to an earthing terminal if no mains earth is available or for joining the earths of other products in the system to improve perfromance in areas of poor/noisy electrical earth conditions.
  3. RIGHT, LEFT SPEAKER - Amplified output for connection to loudspeakers.
  4. ANALOGUE AUDIO OUT - Analogue audio output for connection to an external pre-amplifier or power amplifier if the internal volume control is enabled.
  5. ANALOGUE AUDIO IN - For connection to line-level source products such as a CD player, radiotuner, tape deck, etc.
  6. RC5 IN, OUT - Allowing control of hidden Linn devices connected via their RC5 ports.
  7. IR OUT 1 & 2'- Infrared flasher connectors. Allow the control of devices that accept infra-red signals.
  8. RS232 PORTS - For connection to Linn source products without ethernet ports.
  9. ETHERNET - For connecting the unit to the network.
  10. SPDIF IN - For connection to digital electrical (coaxial) source products, such as a CD players, Set-top boxes, games consoles, DVD players etc.
  11. TOSLINK IN - For connection to digital optical source products, such as a CD players, Set-top boxes, games consoles, DVD players etc.


Front Panel Connections

Image:Sekrit_DSI_front.jpg


  1. POWER SWITCH - For switching power to the unit on and off.
  2. FALLBACK - Used when re-programming the unit.


LED FUNCTIONS

Text

ON

indicates

OFF

indicates

Slow Flash / Blink

Fast Flash

STANDBY Device in standby Device active Searching for IP address (boot) Fallback (reprogramme)
LINK Ethernet link established no link established n/a n/a
DHCP DHCP IP address obtained Default IP address obtained n/a n/a
AUDIO Valid audio (digital inputs only) n/a Invalid audio (digital inputs only) n/a
POWER AMP Internal amplifier enabled Internal amplifier disabled Internal amplifier fault n/a
RCU Reserved for future use Reserved for future use Reserved for future use n/a
SEARCH n/a n/a Find me n/a
TRANSMIT Reserved for future use n/a n/a n/a


Installation

Please read the following carefully before installing the unit in your system – your unit may need to be reconfigured by your Linn retailer.

  • Unpacking - Please read the information on unpacking your Sekrit DS-I.
  • Positioning - Please read the information on positioning your Sekrit DS-I.
  • Important Information:Protection - The Sekrit DS-I features over-current and over-temperature protection

For further assistance, try our customer support pages or the Linn Forum.