Difference between revisions of "DS in Knekt"

From LinnDocs
Jump to: navigation, search
(Linn DS as a Main Knekt Source)
Line 20: Line 20:
  
  
[[File:Main_DS_-_Knekt.jpg]]
+
[[File:Main_DS_-_Knekt.jpg|centre|none]]
  
 
'''Linn DS as a Main Knekt source'''
 
'''Linn DS as a Main Knekt source'''
 
 
 
 
 
  
 
== '''Linn DS as a Local source''' ==
 
== '''Linn DS as a Local source''' ==

Revision as of 15:29, 19 April 2011

Linn DS in a Knekt system

The Knekt-RCU can be programmed to have limited functionality with the Linn DS players via an IR emitter:

Play, Stop, Pause, Skip+ , Skip- & Standby

On some Knekt systems you can also add the search and Kinsky Jukebox selection.

Note: The Knekt-RCU will only control the Linn DS by IR and has no feedback as to which track is playing etc

The important point is that the Knekt-RCU must be programmed for this new source by your Retailer.



Linn DS as a Main Knekt Source

In the drawing below, the Linn DS product is shared throughout your Knekt system. (The Linn DS must be set as source only to shared the full line level audio to each room and let each room decide the volume level)


Main DS - Knekt.jpg

Linn DS as a Main Knekt source

Linn DS as a Local source

The other option is to have the Linn DS as a local room source. This will not share the Linn DS audio to other Knekt rooms, but allow the Linn DS to control some of the Knekt Receivers as preamplifiers. (check the Konfig Proxy RS232 Preamplifier for these products).


The Linn DS only has control of the local Knekt Receiver, if you want to select and control a Main system source, this MUST be performed by the Knekt-RCU. (The Knekt-RCU has standard control of the local room).


DS - Knekt rrom.jpg

Linn DS as a local room


Note: The Majik DSI & Sekrit DSI products CANNOT be used in the Knekt system as the DSI products have inbuilt pre-amplifiers.