Linn Home

DS Configuration

To install, replace or fully reset a DS within the home use the following guide

• Reset device to factory defaults (for a known starting point)
• Update firmware to the latest shipping (non-beta) code
• Install device in the destination room
• Connect inputs/outputs and configure device as follows:
  • (Configuration shows differences from factory defaults)

Kitchen

Connections

• Power
• Ethernet
• Speakers
• Basik3 RCU

Configuration

• Device
  • Room -> Kitchen
  • HDMI -> Disabled
  • Startup Mode -> Active
  • Startup Source -> Radio
  • Startup Source Enabled -> Yes
• Songcast Sender
  • Output Mode -> Multicast
  • Preset -> ?
• Sources
  • All apart from Playlist, Radio and Songcast: Visible -> No
• Tunein Radio
  • Username -> linn.home
• Volume
  • Startup Volume -> 45
  • Startup Volume Enabled -> Yes

Bedroom

• TV connected to HDMI out
• Sky box connected to HDMI1
• BluRay player connected to HDMI2

Study

TV connected to TOSLINK1

Lounge

• TV connected to HDMI out
• Sky box connected to HDMI1
• BluRay player connected to HDMI2
• PS3 connected to HDMI3

Dining Room

• Swap right and left speaker cables (reverse channels) to prevent crossed over stereo imaging in the middle of the home from the lounge speakers

Network Configuration

Netgear WNR2000 Router

• WiFi disabled
• WAN port connected to main Linn network
• LAN ports connected to Cisco switches

Ubiquiti Unifi WAP

• Java control application running on MacMini