Difference between revisions of "KlimaxSolo:Auto-Standby"
(Created page with ":This allows more settings in the Auto-Standby function and overall power used. ::<big><b>3</b></big>: <b><i>No</i></b> auto-standby. (Never enters Low-Power mode) ::<big><b>2...") |
m |
||
| Line 4: | Line 4: | ||
::<big><b>1</b></big>: "<b><i>Deep</i></b>" auto-standby after 20 minutes without a signal. Audio will take a few seconds before waking up. | ::<big><b>1</b></big>: "<b><i>Deep</i></b>" auto-standby after 20 minutes without a signal. Audio will take a few seconds before waking up. | ||
| + | <!-- | ||
:Note: | :Note: | ||
::12V Trigger and Auto-Standby behaviour | ::12V Trigger and Auto-Standby behaviour | ||
| Line 9: | Line 10: | ||
::* with 12V trigger enabled, amp will go into running state but will go into deep or shallow after 20 minutes without signal if switch position 1 or 2. | ::* with 12V trigger enabled, amp will go into running state but will go into deep or shallow after 20 minutes without signal if switch position 1 or 2. | ||
::* with switcn in position 3, amp standby will be fully controlled by 12V trigger in. | ::* with switcn in position 3, amp standby will be fully controlled by 12V trigger in. | ||
| + | ---> | ||
Revision as of 14:46, 22 May 2025
- This allows more settings in the Auto-Standby function and overall power used.
- 3: No auto-standby. (Never enters Low-Power mode)
- 2: "Shallow" auto-standby after 20 minutes without a signal. Almost immediate audio upon waking up.
- 1: "Deep" auto-standby after 20 minutes without a signal. Audio will take a few seconds before waking up.
