|
|
| (One intermediate revision by the same user not shown) |
| Line 1: |
Line 1: |
| − | [[Image:KlimaDS 3Q 02 low res.jpg|right|435x143px]]
| + | #REDIRECT [[Klimax_DSM_/1_(2014_Variant)]] |
| − | | |
| − | == '''Getting Started''' ==
| |
| − | [http://www.linn.co.uk/go/klimax '''www.linn.co.uk/go/klimax''' ]
| |
| − | | |
| − | == '''Product info''' ==
| |
| − | | |
| − | * ''Product Name:'' Klimax DSM/1 (2014 Variant)
| |
| − | ::Other variants of this product can be found at<u> [[Klimax_DSM_Variants|Klimax DSM Variants]]</u><br>
| |
| − | | |
| − | * ''Date of Introduction:''June 2014 - Sept 2016
| |
| − | ::Replaced by [[Klimax_DSM_(KATALYST_Variant)|Klimax DSM/2]] in 2016
| |
| − | * ''Type:'' Integrated digital music player and preamplifier
| |
| − | * [http://small.linncdn.com/product-catalogue/documents/Linn_Klimax_DSM_Product_Information.pdf Product Information sheet]
| |
| − | | |
| − | * ''Features''
| |
| − | ** [http://docs.linn.co.uk/wiki/index.php/Why_Linn_DS_is_the_best_way_to_play_CDs DS Design]
| |
| − | ** [http://docs.linn.co.uk/wiki/index.php/Dynamik Dynamik Power Supply]
| |
| − | ** 192k/24bit Analogue to Digital convertion for Analogue input
| |
| − | ** [[Surround_Sound#Introduction|Surround Sound]]
| |
| − | | |
| − | {{Upgrades:HDMI+SURROUND}}
| |
| − | | |
| − | == '''Support''' ==
| |
| − | | |
| − | [http://www.linn.co.uk/support Linn Support Site]
| |
| − | | |
| − | == '''Latest software''' ==
| |
| − | {{General:Latest_Product_SW}}
| |
| − | | |
| − | == '''Manuals''' ==
| |
| − | | |
| − | [http://small.linncdn.com/product-catalogue/documents/Linn_Klimax_DSM_Quickstart.pdf Quickstart Guide]
| |
| − | | |
| − | {{General:Product_Manuals_Exakt}}
| |
| − | | |
| − | == '''Network Setup''' ==
| |
| − | {{General:DS_Network_system}}
| |
| − | | |
| − | == '''Back Panel Connections''' ==
| |
| − | | |
| − | [[Image:Kli DSM 1 rear.jpg|center|723x326px|Image:Kli DSM 1 rear.jpg]] <br>
| |
| − | | |
| − | # {{link:MAINS INPUT}}
| |
| − | # '''TOSLINK IN'''- To connect sources with Toslink (optical) digital outputs.
| |
| − | # {{link:ETHERNET}}
| |
| − | # '''SPDIF IN''' - To connect sources with Spdif digital outputs.
| |
| − | # {{link:EXAKTLINK}}
| |
| − | # '''EARTH GROUND''' - For connecting the unit to an earthing terminal if no mains earth is available or for joining the earths of other products in the system to improve perfromance in areas of poor/noisy electrical earth conditions.
| |
| − | # '''BALANCED IN RIGHT, LEFT''' - To connect sources with balanced (XLR) outputs. <sup>1 2</sup> (input transformer can be by-passed using Konfig)
| |
| − | # '''BALANCED OUT RIGHT, LEFT''' - To connect to a preamplifier (or power amplifier when internal volume control is enabled) with balanced (XLR) analogue inputs.<sup>2</sup>
| |
| − | # '''UNBALANCED OUT RIGHT, LEFT''' - To connect to a preamplifier (or power amplifier when internal volume control is enabled) with unbalanced (RCA) analogue inputs.<sup>2</sup>
| |
| − | # '''HDMI OUT''' - To connect to a display device with HDMI inputs.
| |
| − | # '''HDMI IN 1, 2, 3''' - To connect sources with HDMI outputs.
| |
| − | # {{link:FALLBACK}}
| |
| − | | |
| − | | |
| − | <BR>
| |
| − | '''<sup>1</sup>''' XLR to RCA adaptors are supplied for connecting sources with unbalanced outputs. <br>Input transformer can be enabled or disabled in [[Konfig_Manual#Input_level.2C_Unity_Gain.2C_Volume_offset | Konfig setup]]<br>
| |
| − | Note: Configuring to RCA will add a ground link to the audio tranformer causing an imbalance in the HOT and COLD XLR connections<br><br>
| |
| − | '''<sup>2</sup>''' Set to DELAY mode > DIRECT to pass through an Analogue volume control to the Analogue out.<br>
| |
| − | Only use the XLR(8) output OR the RCA(9) output, never use both outputs as the RCA will degrade the XLR(8) output audio.<br>
| |
| − | | |
| − | === [[Exakt_link | '''EXAKT LINK connection''']]===
| |
| − | Check [[Exakt_link | '''HERE''']] for information of Exakt link connection
| |
| − | | |
| − | <br>
| |
| − | [[Image:Kli_DSM_1_rear_differences.jpg|right|350px]]<br>
| |
| − | | |
| − | === Klimax DSM/1 differences ===
| |
| − | <br>
| |
| − | Changes to Klimax DSM/1 compared to the Klimax DSM/0
| |
| − | # - '''2off Exakt link sockets''' - To connect speakers/Tuneboxes with Exakt Link. This will allow audio from both the Analogue output and Exakt outputs.
| |
| − | # - '''1off SPDIF input''' - The Klimax DSM/0 has 2off SPDIF inputs
| |
| − | | |
| − | <br><br>
| |
| − | | |
| − | == '''Front Panel''' ==
| |
| − | | |
| − | [[Image:Klimax DSM front.jpg|center|700x206px|Image:Klimax_DSM_front.jpg]]
| |
| − | <br>
| |
| − | | |
| − | # '''DISPLAY'''
| |
| − | # '''ON / OFF SWITCH'''
| |
| − | | |
| − | <br>
| |
| − | | |
| − | == '''Installation''' ==
| |
| − | | |
| − | Please read the following carefully '''before''' installing the unit in your system – your unit may need to be reconfigured by your Linn retailer.
| |
| − | | |
| − | * [http://docs.linn.co.uk/wiki/index.php/product_unpacking Unpacking Information]
| |
| − | | |
| − | * [http://docs.linn.co.uk/wiki/index.php/product_positioning Positioning Information]
| |
| − | | |
| − | * [[Structured_Wiring | Structured Wiring information]]
| |
| − | | |
| − | == '''Exakt Options''' ==
| |
| − | Exakt usage the the Exakt Klimax speakers can be found at [http://docs.linn.co.uk/wiki/index.php/Klimax_Exakt_System Klimax Exakt System]
| |
| − | | |
| − | Check [[ExaKt_Trouble_shooting | Exakt trouble shooting]] if you have any issues with the Exakt system.
| |
| − | | |
| − | | |
| − | == '''FAQ's''' ==
| |
| − | Check:
| |
| − | :* [[FAQ-Linn DS/DSM|'''<u>FAQ-Linn DS/DSM</u>''']]
| |
| − | :* [[FAQ-Linn_DS/DSM#Klimax_DS.2FDSM|'''<u>FAQ Klimax DS/DSM</u>''']]
| |
| − | :* [[ExaKt_Trouble_shooting | '''<u>Exakt trouble shooting</u>''']]
| |
| − | | |
| − | | |
| − | For further assistance, try our [http://www.linn.co.uk/linn_customer_support customer support] pages
| |
| − | [[Category:Linn_DSM]][[Category:Exakt]]
| |
