Difference between revisions of "Majik DS"

POWER SWITCH- To switch the power on/off.
MAINS INPUT - To connect to the mains electricity supply.
EARTH GROUND - To connect to an earthing terminal if no mains earth is available or to join to the earths of other products in the system to improve perfromance in areas of poor/noisy electrical earth conditions.
ETHERNET - To connect to a network (100Base-T)
FALLBACK - To put the device into Fallback mode (used when reprogramming)
RS232 PORTS - To connect to other Linn devices that don't have ethernet.
SPDIF OUT - To connect to an external DAC or computer that has an Spdif input.
TOSLINK OUT - To connect to an external DAC or computer that has a TOSLINK input.
ANALOGUE AUDIO OUTPUTS - To connect to a preamplifier (or power amplifier when internal volume control is enabled) with unbalanced (RCA) analogue inputs.

Front Panel Connections

Please read the following carefully before installing the unit in your system – your unit may need to be reconfigured by your Linn retailer.

Key points

"No Network/LAN" indicates that the Linn DS/DSM/HUB does not have a live computer network connection. This can simply be that the cable is loose or that your computer network/LAN is off/not connected.
! indicates that the Linn DS/DSM/HUB is expecting to see all of the pre-configured Exakt devices, (Exakt speakers, Exakrbox.., Urika-II) connected but it cannot see them. This is typically because the Exakt devices are physically disconnected from the Exakt-link network, they physically have no power going to them or the Linn DS/DSM/HUB has prevously been configured for these products but have not been removed from its setup.

Check:

For further assistance, try our customer support pages

@@ Line 35: / Line 35: @@
 == '''Network Setup''' ==
-[[DS Budget System| DS Budget System Setup]]
+{{General:DS_Network_system}}
-[[DS Entry Level System| DS Entry Level System Setup]]
-[[DS High End System| DS High End System Setup]]
 == '''Back Panel Connections''' ==