Difference between revisions of "Sekrit DS-I"

MAINS INPUT - To connect to the mains electricity supply.
EARTH GROUND - To connect to an earthing terminal if no mains earth is available or to join to the earths of other products in the system to improve performance in areas of poor/noisy electrical earth conditions.
SPEAKER OUTPUTS - To connect to loudspeakers.
ANALOGUE OUTPUTS (RCA, variable/fixed level) - To connect to a preamplifier (or power amplifier when internal volume control is enabled) with unbalanced (RCA) analogue inputs.
ANALOGUE INPUTS (RCA, line level) - To connect sources with unbalanced (RCA) analogue outputs.
RC5 ACCESSORY - To connect to a Linn BASIK3 or BASIK3-IR Knekt control device, (setup for RoomAmp2 connection (jumper link removed)). This requires a Knekt-CAT-5 cable to connect to the Linn DS
IR OUTPUTS - To connect to infrared flasher devices allowing control of other products that accept infra-red signals.
RS232 PORTS - To connect to other Linn devices that don't have ethernet.
ETHERNET - To connect to a network (100Base-T)
DIGITAL INPUT (Spdif) - To connect sources with Spdif (RCA) digital outputs.
DIGITAL INPUT (Toslink) - To connect sources with Toslink (optical) digital outputs.

Front Panel Connections

LED FUNCTIONS

Text	ON indicates	OFF indicates	Slow Flash / Blink	Fast Flash
STANDBY	Device in standby	Device active	Searching for IP address (boot)	Fallback (reprogramme)
LINK	Ethernet link established	no link established	n/a	n/a
DHCP	DHCP IP address obtained	Default IP address obtained	n/a	n/a
AUDIO	Valid audio (digital inputs only)	n/a	Invalid audio (digital inputs only)	n/a
POWER AMP	Internal amplifier enabled	Internal amplifier disabled	Internal amplifier fault	n/a
RCU	Reserved for future use	Reserved for future use	Reserved for future use	n/a
SEARCH	n/a	n/a	Find me	n/a
TRANSMIT	Reserved for future use	n/a	n/a	n/a

Please read the following carefully before installing the unit in your system – your unit may need to be reconfigured by your Linn retailer.

Check:

For further assistance, try our customer support pages

@@ Line 56: / Line 56: @@
 [[Image:Sekrit DSI rear.jpg|center|600x328px|Image:Sekrit_DSI_rear.jpg]] <br>
-# '''MAINS INPUT''' - To connect to the mains electricity supply.
+# {{link:MAINS INPUT}}
 # '''EARTH GROUND''' - To connect to an earthing terminal if no mains earth is available or to join to the earths of other products in the system to improve performance in areas of poor/noisy electrical earth conditions.
 # '''SPEAKER OUTPUTS''' - To connect to loudspeakers.
@@ Line 64: / Line 64: @@
 # '''IR OUTPUTS''' - To connect to infrared flasher devices allowing control of other products that accept infra-red signals.
 # '''RS232 PORTS''' - To connect to other Linn devices that don't have ethernet.
-# '''ETHERNET''' - To connect to a network.
+# {{link:ETHERNET}}
 # '''DIGITAL INPUT''' (Spdif) - To connect sources with Spdif (RCA) digital outputs.
 # '''DIGITAL INPUT''' (Toslink) - To connect sources with Toslink (optical) digital outputs.
@@ Line 77: / Line 77: @@
 # '''POWER SWITCH''' - Switches the power on/off
-# '''FALLBACK BUTTON''' - To put the device into Fallback mode (used when reprogramming)
+# {{link:FALLBACK}}
 <br>'''LED FUNCTIONS'''