REM 020

From LinnDocs
Revision as of 10:30, 20 December 2011 by Hahnj21 (talk | contribs)
Jump to: navigation, search

Operation with Linn DSM

The following functionality is available on Linn DSM devices with Infra-Red (IR) control. If IR is not currently enabled on the Linn DSM then this can be done via Linn Konfig.

This IR handset can be used with ALL Linn DS/DSM Products, some functionality is configured by Linn Konfig.

To Enable IR

  • Open Konfig
  • Select the Linn DSM
  • Select the Configuration tab
  • Set Handset Commands Accepted to All or CD depending on user requirement


Basic Functions

Image:remote.jpg


  1. SLEEP - Will put the unit into / out of Sleep mode.
  2. NUMERICAL KEYS - Numerical input.
  3. # - Press and hold for 2 seconds for HELP information
    e.g. IP address, MAC etc.
  4. * - No function.
  5. NAVIGATION / SELECT - Up / down / left /right / enter keys for playlist navigation.
  • Left and right keys will seek through tracks during playback
  1. DS SOURCE SELECTION - For switching between "Songcast",
    "Playlist" and "Radio" sources on your DSM.
  2. INPUT SOURCE SELECTION - Direct source selection buttons,
    see below for default settings and how to change them.
  3. TRANSPORT CONTROLS - Play, pause, skip forward, skip back.
  • Press and hold pause will stop playback
  1. MUTE - To mute / unmute volume.
  2. VOLUME + , - - Volume + , -.
  3. SOURCE + , - - Source + , -.
  4. INFORMATION - changes information displayed on the DSM
    front panel
  • Press and release - toggles different display modes e.g. track
number, bit rate etc
  • Press and hold scrolls title / artist / album information






Direct Source Selection


The default settings for the direct source selection buttons is shown below.

Product Source 1 Source 2 Source 3
Klimax DSM hdmi 1 hdmi 2 hdmi 3
Akurate DSM hdmi 1 hdmi 2 hdmi 3
Majik DSM tos 1 tos 2 tos 3




These settings can be changed either with the handset or using Linn Konfig.

Using the handset

  • On the DSM, go to the source that you want the remote button to select.
  • Press and hold the chosen source button on the handset e.g. Drawing1.jpg
until the DSM displays Drawing1.jpg SET.

Using Konfig

  • Open Konfig and select the unit you want to update
  • Open the Configuration tab
  • Scroll down to the section Slimline Handset
  • Highlight the Input button you wish to change and then select the source from the drop down list.