Difference between revisions of "REM 020"

From LinnDocs
Jump to: navigation, search
(Operation with Linn DSM)
(Direct Source Selection)
Line 104: Line 104:
 
:::until the DSM displays    '''[[Image:drawing1.jpg]] SET'''.
 
:::until the DSM displays    '''[[Image:drawing1.jpg]] SET'''.
  
'''Using Linn Konfig'''
+
'''Using Konfig'''
::* Open Linn Konfig and select the unit you want to update
+
::* Open Konfig and select the unit you want to update
 
::* Open the '''Configuration''' tab
 
::* Open the '''Configuration''' tab
 
::* Scroll down to the section '''Slimline Handset'''
 
::* Scroll down to the section '''Slimline Handset'''

Revision as of 12:54, 13 October 2011

Operation with Linn DSM

The following functionality is available on Linn DSM devices with Infra-Red (IR) control. If IR is not currently enabled on the Linn DSM then this can be done via Linn Konfig.

To Enable IR

  • Open Konfig
  • Select the Linn DSM
  • Select the Configuration tab
  • Set Handset Commands Accepted to All or CD depending on user requirement


Basic Functions

Image:remote.jpg


  1. SLEEP - Will put the unit into / out of Sleep mode.
  2. NUMERICAL KEYS - Numerical input.
  3. # - Press and hold for 2 seconds for HELP information
    e.g. IP address, MAC etc.
  4. * - No function.
  5. NAVIGATION / SELECT - Up / down / left /right
    / enter keys for playlist navigation.
  6. DS SOURCE SELECTION - For switching between "Songcast",
    "Playlist" and "Radio" sources on your DSM.
  7. INPUT SOURCE SELECTION - Direct source selection buttons,
    see below for default settings and how to change them.
  8. TRANSPORT CONTROLS - Play, pause, skip forward, skip back.
  9. MUTE - To mute / unmute volume.
  10. VOLUME + , - - Volume + , -.
  11. SOURCE + , - - Source + , -.
  12. INFORMATION - changes information displayed on the DSM
    front panel
  • Press and release - toggles different display modes e.g. track
number, bit rate etc
  • Press and hold scrolls title / artist / album information






Direct Source Selection


The default settings for the direct source selection buttons is shown below.

Product Source 1 Source 2 Source 3
Klimax DSM hdmi 1 hdmi 2 hdmi 3
Akurate DSM hdmi 1 hdmi 2 hdmi 3




These settings can be changed either with the handset or using Linn Konfig.

Using the handset

  • On the DSM, go to the source that you want the remote button to select.
  • Press and hold the chosen source button on the handset e.g. Drawing1.jpg
until the DSM displays Drawing1.jpg SET.

Using Konfig

  • Open Konfig and select the unit you want to update
  • Open the Configuration tab
  • Scroll down to the section Slimline Handset
  • Highlight the Input button you wish to change and then select the source from the drop down list.