REM 020

Operation with Linn DSM

The following functionality is available on Linn DSM devices with Infra-Red (IR) control. If IR is not currently enabled on the Linn DSM then this can be done via Linn Konfig.

This IR handset can be used with ALL Linn DS/DSM products. Some functionality is configured by Linn Konfig.

To Enable IR

• Open Konfig
• Select the Linn DSM
• Select the Configuration tab
• Set Handset Commands Accepted to All or CD depending on user requirement

Basic Functions

1. SLEEP - Will put the unit into / out of Sleep mode.
2. NUMERICAL KEYS - Numerical input.
3. # - Press and hold for 2 seconds for HELP information

   e.g. IP address, MAC etc.

4. * - No function.
5. NAVIGATION / SELECT - Up / down / left /right / enter keys for playlist navigation.

   • Left and right keys will seek through tracks during playback

6. DS SOURCE SELECTION - For switching between "Songcast",

   "Playlist" and "Radio" sources on your DSM.

7. INPUT SOURCE SELECTION - Direct source selection buttons,

   see below for default settings and how to change them.

8. TRANSPORT CONTROLS - Play, pause, skip forward, skip back.

   • Press and hold pause will stop playback

9. MUTE - To mute / unmute volume.
10. VOLUME + , - - Volume + , -.
11. SOURCE + , - - Source + , -.
12. INFORMATION - changes information displayed on the DSM

    front panel

• Press and release - toggles different display modes e.g. track

number, bit rate etc

• Press and hold scrolls title / artist / album information

Direct Source Selection

For Linn DSM/DSI products and Akurate Kontrol/1

If you are using an Akurate Kontrol/1 and a Linn DS, when you select the Playlist, Radio & Songcast buttons, you will have to select the Linn DS on the Akurate Kontrol/1 from the direct source selection buttons.

The default settings for the direct source selection buttons is shown below.

Product	Source 1	Source 2	Source 3
Klimax DSM	hdmi 1	hdmi 2	hdmi 3
Akurate DSM	hdmi 1	hdmi 2	hdmi 3
Majik DSM	tos 1	tos 2	tos 3

These settings can be changed either with the handset or using Linn Konfig.

Using the handset

• On the DSM, go to the source that you want the remote button to select.
• Press and hold the chosen source button on the handset e.g.

until the DSM displays SET.

Using Konfig

• Open Konfig and select the unit you want to update
• Open the Configuration tab
• Scroll down to the section Slimline Handset
• Highlight the Input button you wish to change and then select the source from the drop down list.